MAPLUS PRO SET for Teams and Coaches ; Save 25%

Special Team offer for the best Fluor free World Cup set . GM BASE + GM BOOST Powder.  SAVE 25% by purchasing the entire World Cup SET.

GM BASE :                            1x COLD , 1 x MED , 1 x HOT

GM BOOST POWDER :        1x COLD , 1 x MED , 1 x HOT

Innovative products crafted with revolutionary components designed to enhance

skiing experience.

Not only they perform exceptionally, but also have a minimal environmental impact.

Proud to offer visionary products that meet both of those criteria.

Powder: 

HOT APPLICATION WITH WAXING IRON

1. Spread powder wax evenly on the ski base;

2. Melt the wax passing the waxing iron from the tip to the tail at recommended

temperature of 160°C; move the iron at a constant speed (nearly 3 cm per second);

3. Wait at least few minutes for the ski wax to harden and the ski base to cool down;

4. If necessary, remove the excess of melted wax with a sharpened plexy scraper with

gentle pressure;

5. Free the ski base structure with manual soft brass brush;

6. Brush the ski base with manual or roto hard horsehair brush;

7. Brush the ski base with manual or roto soft nylon brush;

SOLID wax:

HOT APPLICATION WITH WAXING IRON

1. Let the wax block drop on 20 cm of the ski base putting it in contact with the waxing iron base at

the recommended temperature for each kind of product and melt the wax immediately spreading

it with a regular backward and forward movement (from tip to tail);

2. Repeat the same procedure on all the ski base, then carry out a final passage from the tip to the tail

(nearly 4/5 cm per second for GM BASE Cold and Med, nearly 3 cm per second for GM BASE Hot);

3. (mix with hardener) If snow conditions should require an harder base, over the GM BASE layer

just hardened, place some ARTIC BASE powder (higher will be the snow abrasion, bigger will be

the quantity of powder) and carry out a slow passage (nearly 3 cm per second) with the waxing

iron at 150°C. melting perfectly the powder inside the solid wax;

4. Free the ski & edge side from the hardened wax with a plexy scraper;

5. Wait at least 15 minutes for the ski wax to harden and the ski base to cool down, then remove

the wax in excess with a sharpened plexy scraper with gentle pressure;

6. Free the ski base structure with manual hard steel brush;

7. Brush the ski base with manual or roto hard brass brush;

8. Brush the ski base with manual or roto hard horsehair brush;

9. Polish the ski base with manual or roto soft nylon brush.